eSUN 1.75mm PLA PRO (PLA+) 3D Printer Filament 1KG Spool (2.2lbs), Gray

Gray

1 year replacement

$13.59

~~$27.99~~ SAVE 51%

buy 2 for $12.89 each (save 5%)

CLEARANCE 20% OFF

eSUN 3D Printer Filament: PLA PRO (PLA+)

PLA+ is like PLA, but better! As compared to PLA, PLA+ (PLA PRO) is:

Several times stronger than standard PLA (printouts are very hard to break!)
Superb layer bonding
High rigidity
Better glossiness
Smoother finish
No cracking or brittle problems

Specification:

1KG net (approximately 2.2 lbs) PLA Filament with Clear Spool
eSUN PLA PRO 3D Printer Filament Vacuumed Sealed With Desiccant. Superb layer bonding.
1.75mm Filament Diameter (Dimensional Accuracy +/- 0.05mm)
Recommended Extrusion/Nozzle Temperature 205C - 225C
Spool Diameter: 8" - Spool Width: 2.50" - Spool Hub Hole Diameter: 2.05" - Inner Circle Diameter: 3.5"
Extrusion Temperature Range: 205 to 225 Celsius
PLA PRO (PLA+) print temperature is about 20 Celsius higher than regular PLA. Most users print at around 210 to 215 Celsius.
PLA+ has a low shrinkage rate and sticks very well both to bed and layer to layer.
PLA+ is a biological material, extracted and purified from corn grain, eco-friendly, odorless, and harmless to human.

This product is vacuum packed with a manual. It is not easy to absorb moisture and is ok for long-term storage. It absorbs slower and less moisture than standard PLA. WARNING: Luminous compound is abrasive to hotend. Always use all-metal hotend.

Item #: ESUNPLAPLUSGRA

PROP 65 WARNING: This product may contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
www.P65Warnings.ca.gov

Compatible with the following 3D printers:

· Eventorbot
· Makemendel Ditto 3D
· MakerBot
· MAX Airwolf 3D Series 1
· Mendels
· Portabee

· POWERWASP
· Printrbot
· Printrbot LC
· RigidBot 3D
· Robo 3D
· Romscraj

· Rostock
· Solidoodle
· Sumpod
· Up!

Frequently Asked Questions:

What's the difference between ABS and PLA?

Acrylonitrile Butadiene Styrene (ABS) is lightweight and it has a lower coefficient of friction. That makes it preferred material for small parts, compared to PLA. ABS has to be extruded at a higher temperature. Its glass transition temperature is around 105°C/220F. ABS is amorphous and therefore has no true melting point, however 230°C/445F is the standard for 3D printing. Most LEGO is made of ABS.

Polylactic acid (PLA) is a bio-degradable polymer derived from corn starch. It is melts at a lower temperature around 180°C/355F, and a glass transition temperature around 60°C/140F. It does exhibit higher friction which can make it difficult to extrude. PLA will flow more easily than ABS at the same temperatures and usually more glossy.

ORDER BY PHONE: 866-265-0206

eSUN 1.75mm PLA PRO (PLA+) 3D Printer Filament 1KG Spool (2.2lbs), Gray

Compatible with the following 3D printers:

Frequently Asked Questions: