eSUN 1.75mm PLA PRO (PLA+) 3D Printer Filament 1KG Spool (2.2lbs), Orange

Orange

1 year replacement

$15.29

$27.99 SAVE 45%

buy 2 for $14.49 each (save 5%)

eSUN 3D Printer Filament: PLA PRO (PLA+)

PLA+ is like PLA, but better! As compared to PLA, PLA+ (PLA PRO) is:

• Several times stronger than standard PLA (printouts are very hard to break!)
• Superb layer bonding
• High rigidity
• Better glossiness
• Smoother finish
• No cracking or brittle problems

• 1KG net (approximately 2.2 lbs) PLA Filament with Clear Spool
• eSUN PLA PRO 3D Printer Filament Vacuumed Sealed With Desiccant. Superb layer bonding.
• 1.75mm Filament Diameter (Dimensional Accuracy +/- 0.05mm)
• Recommended Extrusion/Nozzle Temperature 205C - 225C
• Spool Diameter: 8" - Spool Width: 2.50" - Spool Hub Hole Diameter: 2.05" - Inner Circle Diameter: 3.5"
• Extrusion Temperature Range: 205 to 225 Celsius
• PLA PRO (PLA+) print temperature is about 20 Celsius higher than regular PLA. Most users print at around 210 to 215 Celsius.
• PLA+ has a low shrinkage rate and sticks very well both to bed and layer to layer.
• PLA+ is a biological material, extracted and purified from corn grain, eco-friendly, odorless, and harmless to human.

This product is vacuum packed with a manual. It is not easy to absorb moisture and is ok for long-term storage. It absorbs slower and less moisture than standard PLA. WARNING: Luminous compound is abrasive to hotend. Always use all-metal hotend.

Item #: ESUNPLAPLUSORANGE